Installation With Weld-On Pedestals - V.ORLANDI Rp10 Instructions De Montage, D'utilisation Et D'entretien

2.3 INSTALLATION WITH WELD-ON PEDESTALS

N
All welding operations must strictly be performed only by qualified
O
personnel.
T
E
Position the fifth wheel onto the tractor unit's carrier plate;
1)
Fix the weld-on pedestals (31) onto the carrier plate with a few welding spots;
2)
Unscrew the fifth wheel from the weld-on pedestals (31) as per points 1 and 2
3)
in section 7.1.2 - FIFTH WHEEL WITH PIVOT BEARINGS - page 29/36;
4)
Proceed with welding the weld-on pedestals (31) completely by welding
them around the whole pedestal rim as per directions supplied with the fifth
wheel homologation
5)
Re-assemble the fifth wheel plate as specified in points 4 and 5 in section
7.1.2 FIFTH WHEEL WITH PIVOT BEARINGS - page 29/36.
31
N
O
Once installation is complete, proceed as instructed in section 2.4 -
T
SETTING UP FOR OPERATION - page 13/36.
E
INSTALLATION, OPERATING AND MAINTENANCE INSTRUCTIONS INSTALLATION, OPERATING AND MAINTENANCE INSTRUCTIONS
documents;
FIFTH WHEEL Rp10
Carrier plate
Truck side chassis
PAG.
12/36
CHAP . 2
REV. 00
31