Operation; General - Hatco Toast Qwik TQ-10 Série Manuel D'installation Et D'utilisation

OPERATION

General

The Toast-Qwik Conveyor Toaster is designed for ease of
®
operation. To operate the toaster perform the appropriate
procedure in this section.
WARNING
Read all safety messages in the IMPORTANT SAFETY
INFORMATION section before operating this equipment.
CAUTION
BURN HAZARD:
• Some exterior surfaces on unit will get hot. Use caution
when touching these areas.
• Do not remove crumb tray for cleaning until toaster is
cool.
If warning light comes on, unit is malfunctioning due to fan
failure. Turn off unit, disconnect from power supply, and
have unit serviced by a qualified technician.
Always operate toaster with crumb tray installed.
The toasting of coated or buttered products such as
garlic bread, cheese sandwiches, and sweet rolls is NOT
recommended. Residue will reduce toaster performance
and could ignite inside the toaster. Using the toaster with
the food products listed above will void the unit warranty.
Color Control
TQ-10 Models
Control Panel
The following are descriptions of the controls used to operate
the unit. All controls are located on the control panel on the
front of the unit.
Top Heat I/O Switch
The Top Heat ( ) I/O Switch controls power to the top heating
element. The icon indicates that the heat will radiate down from
above.
Bottom Heat I/O Switch
The Bottom Heat ( ) I/O Switch controls power to the bottom
heating element. The icon indicates that the heat will be rise up
from below.
Color Control
The Color Control adjusts the toasting color using the speed
of the conveyor. Turning the Color Control clockwise will toast
products to a darker color ( ). Turning the Color Control
counterclockwise will toast products to a lighter color ( ).
Operating TQ-10 Models
1. Plug toaster into a properly grounded electrical outlet of
the correct voltage, size and plug configuration. See the
SPECIFICATIONS section for details.
2. Move the
• To toast the top and bottom sides of the bread, move
the
• To toast on the top side only, move the
in the I position and the
• To toast on the bottom side only, move the
in the O position and the
3. Turn the Color Control to the lightest position while the unit
heats up.
NOTE: Allow approximately 15 to 20 minutes for a warm-up
period.
4. After warm-up period, set the Color Control to the medium
position and toast two slices of bread product then re-
adjust the Color Control to the desired setting.
NOTE: To toast moist products such as English Muffins, rye
bread or whole wheat, slow the conveyor by turning the
Color Control knob to a darker setting (clockwise).
Bottom Heat I/O (on/off) Switch
Top Heat I/O (on/off) Switch
Control Panel – TQ-10 Series
12
I/O switches to the I position.
and/or
and I/O switches to the I (on) position.
I/O switch to the O position.
I/O switch to the I position.
Form No. TQ2CEM1-1120
I/O switch
I/O switch