Problems And Corrective Actions - Krups ESPRESSERIA AUTOMATIC EA80 Série Mode D'emploi

You can stop your appliance at all times: the appliance will emit two beeps and then it will
stop soon afterwards.

PROBLEMS AND CORRECTIVE ACTIONS

PROBLEMS
The appliance does not
switch on when the "On/Off"
is pressed.
Water or steam comes
incorrectly out of the steam
nozzle.
The espresso or coffee is not
hot enough.
The coffee is too light or not
strong enough.
The coffee flows too slowly.
The coffee is not creamy
enough.
The appliance does not serve
any coffee.
Why can I not run descaling/
why does my machine not
request a descaling cycle?
You have used ground coffee
instead of bean coffee.
The grinder makes a strange
noise.
The grinding fineness knob is
hard to turn.
24
CORRECTIVE ACTIONS
Check that the plug of the power cord is pushed
correctly into the mains socket.
In case of repeated operation, several drops may drip
from the steam nozzle.
Change the coffee temperature setting.
Heat the cups by rinsing them with hot water.
Check that the coffee bean tank has coffee in it and that
it is flowing correctly. Avoid using oily, caramelised or
flavoured coffee.
Reduce the volume of coffee using the central knob.
Turn the grinding fineness knob towards the left for
a finer grind. Prepare in two cycles using the 2 cup
function.
Turn the grinding fineness knob towards the right for a
coarser grind (may depend on the type of coffee used).
Carry out one or two rinsing cycles.
Turn the grinding fineness knob towards the left for a
finer grind (may depend on the type of coffee used).
Change the Claris Aqua Filter System cartridge (follow
the installation procedure on page 13).
Carry out one or two rinsing cycles.
An incident has been detected during the preparation.
The appliance resets itself automatically and is then
ready for a new cycle.
The machine only requests a descaling cycle once it has
made a certain number of drinks using steam.
Use your vacuum cleaner to suck out the pre-ground
coffee in the coffee bean tank.
There are foreign particles in the grinder. Contact
KRUPS' Customer Service.
Only change the grinder setting when it is operating.