Preparing The Grinder; Preparing Espresso And Ordinary Coffee - Krups ESPRESSERIA AUTOMATIC EA80 Série Mode D'emploi

Preparing the grinder

Adjust the fineness of your coffee grinding to set the strength of your coffee. The finer the
grind setting, the stronger and creamier the coffee will be.
Turn the "Grinding fineness setting" button to set the degree of grinding fineness. Turn
anticlockwise for a finer grind. Turn clockwise for a coarser grind. - Fig. 15.
CHANGE THE SETTING DURING GRINDING.
NEVER FORCE THE GRINDING FINENESS SETTING BUTTON.

PREPARING ESPRESSO AND ORDINARY COFFEE

YOUR APPLIANCE IS DESIGNED TO MAKE COFFEE FROM COFFEE BEANS ONLY.
When you first make coffee with the machine or after a long period of absence or a
cleaning or scale removal procedure, a little steam and hot water will come out of the
steam nozzle (priming).
Splashing or scalding may occur if the coffee outlets are set too high in relation to the
size of the cups.
Preparing an espresso
The quantity of water for an espresso must be between 20 and 70 ml.
Press the button, wait for the end of pre-heating and perform a rinsing operation if you
wish. Each time you plug your machine in, it will carry out an initialisation cycle.
The drink selection menu will be displayed - Fig. 16.
Put a cup under the coffee outlets. You can lower or raise the coffee outlets to suit the size
of your cups - Fig. 17. Use the rotating button to select your drink - Fig. 12 and confirm by
pressing the OK key - Fig. 13.
You can change the volume of water at any time using the rotating button - Fig. 12.
To stop coffee flowing into the cup, you can either again press a key or turn the
rotating button to reduce volume.
Making a coffee
The amount of water required for a coffee is between 80 and 160 ml.
Making a long coffee
The amount of water required for a long coffee is between 120 and 240 ml. The machine
automatically carries out a double cycle, do not remove your cup before the process has
ended.
The ground coffee is first moistened using a little hot water after the grinding stage. A
few moments later, percolation as such begins.
There is a temperature setting function to control how hot your coffee is.
DO NOT REMOVE THE WATER COMPARTMENT BEFORE THE END OF THE CYCLE
(that is around 15 seconds after the coffee has finished dripping through).
2-cup function
Your appliance enables you to prepare 2 cups of coffee or espresso for the following 3
kinds of drink : espresso / strong espresso / coffee. For "Large coffee" drinks, the 2-cup
function is not available. Remember not to remove the cups after the first cycle. You have
18