Maintenance - RIDGID JobMax R8223500 A Série Manuel D'utilisation

OPERATION
INSTALLING/REMOVING BATTERY PACK
See Figure 2, page 8.
 To install, lock the switch trigger and insert the battery
pack.
 Make sure the latches on each side of the battery pack
snap in place and that battery pack is secured in the
product before beginning operation.
 To remove, depress the latches.
INSTALLING/REMOVING ACCESSORY
HEADS
See Figures 3 - 4, page 8.
 Lock the switch trigger and remove the battery pack.
 Depress the latches on both sides of the power handle
with one hand while pulling the head away from the tool
with your other hand.
 Place the desired accessory head on the power handle
and push until the latches click into position. Pull on the
head to make sure it is securely installed before operation.
NOTE: The head can be installed at 90° angles to best
suit your application needs.

MAINTENANCE

WARNING:
When servicing, use only identical replacement
parts. Use of any other parts could create a hazard
or cause product damage.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
REPLACING THE DRIVE GEAR COVER
See Figure 5, page 8.
If over time you notice the noise of the tool getting louder
than usual, check the condition of the drive gear cover. If
the cover is excessively damaged so that the metal gear is
clearly visible, remove it and replace with the spare drive
gear cover included.
NOTE: Figures (illustrations) start on page 8 after French and Spanish language sections.
This product has a 90-day satisfaction guarantee policy, as well as a three-year
limited warranty. For warranty and policy details, please go to www.RIDGID.com
ON-BOARD FUEL GAUGE
See Figure 1, page 8.
The on-board fuel gauge lights up to indicate the amount of
charge in the battery pack when the operator pulls the trigger.
One LED begins flashing when
the battery pack needs to be
recharged.
NOTE: To reduce the noise level of the tool, do not operate
without the drive gear cover installed.
BATTERY PACK PREPARATION FOR
RECYCLING
or call (toll free) 1-866-539-1710.
6 - English
LED INDICATOR
WARNING:
Upon removal, cover the battery pack's terminals
with heavy-duty adhesive tape. Do not attempt to
destroy or disassemble battery pack or remove
any of its components. Batteries must be recycled
or disposed of properly. Also, never touch both
terminals with metal objects and/or body parts as
short circuit may result. Keep away from children.
Failure to comply with these warnings could result
in fire and/or serious injury.
% CHARGED
0%-25%
26%-50%
51%-75%
76%-100%