Bosch Power Xpress Dual Bollard Instructions D'installation page 13

25. Use a small flat-blade screwdriver or similar tool to
guide the upper plastic cover into seal.
26. While gently pressing down on the upper plastic
cover, carefully slide the screwdriver around the
bollard to extend the upper lip of the seal over the
upper plastic cover. The upper cover may need to be
tapped gently to fully seat it in the seal.
CAUTION: Use care not to cut or damage
the seal during this procedure.
Bosch Automotive Service Solutions Inc.
Power Xpress™ Dual Bollard Charge Station Installation Guide | 11 | en
27. With assistance, move bollard next to the prepared
site.
28. Feed cords into the junction box and secure cable
glands.
29. Wire cords to the supply wires and seal the junction
box with a cover suitable for wet location.
30. With assistance, lift bollard onto mounting bolts.
31. Level, adjust, and tighten mounting nuts according
to anchor manufacturer specification.
32. Loop the cables onto the cable-management holder.
33. Remove the strain-relief assembly from the wiring
chamber.
576414 | REV. B | 28.10.2016