Getting Started; Resetting The Unit; Setting The Clock; Detaching The Front Panel - Sony CDX-GT805DX Mode D'emploi

Getting Started

Resetting the unit

Before operating the unit for the first time, or
after replacing the car battery or changing the
connections, you must reset the unit.
Detach the front panel and press the RESET
button with a pointed object, such as a ball-point
pen.
RESET button
Note
Pressing the RESET button will erase the clock setting
and some stored contents. Custom memory of HDEQ,
DSO 3D and Intelligent Time Alignment (I-TA) will not
be erased (page 11).

Setting the clock

The clock uses a 12-hour digital indication.
1
Press (MENU).
2
Rotate the SEEK control dial until
"SETUP" appears, then press
(ENTER).
3
Rotate the SEEK control dial until
"Clock Adjust" appears, then press
(ENTER).
The clock adjustment display appears.
4
Rotate the SEEK control dial to set the
hour and minute.
To move the digital indication, press
(ENTER).
5
After setting the minute, press
(ENTER).
The clock starts.
With the card remote commander
In steps 2 to 4: press M or m instead of the SEEK
control dial; in step 4: press < or , instead of
(ENTER).
4

Detaching the front panel

You can detach the front panel of this unit to
prevent theft.
Caution alarm
If you turn the ignition switch to the OFF
position without detaching the front panel, the
caution alarm will sound for a few seconds.
The alarm will only sound if the built-in
amplifier is used.
1
Press (OFF).
The unit is turned off.
2
Press .
The left side of front panel is released.
3
Slide the front panel to the left, then
gently pull out the front panel towards
you.
(OFF)
1
Notes
• Do not drop or put excessive pressure on the front
panel and display window.
• Do not subject the front panel to heat/high
temperature or moisture. Avoid leaving it in a parked
car or on a dashboard/rear tray.
2