Britax Roundabout Canadian Guide De L'utilisateur page 19

Care and Maintenance
Refitting the Cover
To refit the cover, reverse the previous directions. Make sure the
harness straps are properly threaded through the chest clips and
the harness is not twisted.
Cleaning the Cover
• HAND WASH using cold water and mild soap.
• LINE or LIE-FLAT DRY to prevent the cover from shrinking.
• DO NOT bleach, machine wash, machine dry or iron.
Cleaning the Shell
• SPONGE CLEAN using warm water and mild soap.
• TOWEL DRY
• DO NOT use solvents, abrasive cleaners or disassemble the
harness.
Cleaning the Harness
• SPONGE CLEAN using warm water and mild soap.
• TOWEL DRY
• DO NOT bleach, machine wash, machine dry or disassemble
the harness.
34
Harness Buckle Removal
1 Fully recline the child seat.
2 Locate the metal buckle strap retainer
on the bottom of the child seat.
3 Pull the retainer away from the child
seat to loosen.
4 Turn the retainer so the short side will
go through the slot in the child seat shell
(Fig. A).
5 Push the retainer through the slots in the shell and cover to the
top of the child seat.
Re-threading the Harness Buckle
1 Locate the slot in the cover and shell for the harness buckle.
2 Turn the metal buckle strap retainer so the short side will go
through the slot in the cover and the child seat shell (Fig A).
3 Push the retainer through the slots in the shell and cover, to the
bottom of the child seat.
4 Pull the harness buckle away from the child seat until tight and
verify the harness buckle strap is not twisted and the release
button is facing outward.
Care and Maintenance
A
35