Gazelle innergy Manuel De L'utilisateur page 69

Charging the battery separate from the bike:
• Comply with the above charging instructions.
• R emove the battery from the bike in accordance
with the previously given instructions.
• P ut the battery on a flat, hard surface in the vicinity
of a power socket.
• O pen the rubber cover cap of the battery charge
plug, on the rear left at the taillight, and put in the
power plug of the charger. (Photo 15)
• M ake sure that the power plug sits firmly in the
battery. (Photo 16)
• Put the power plug in the socket.
• The LED in the rear light flashes when you connect
the charger correctly. On the charger itself a green
light will be on, indicating that the charger is in use.
• T he flashing LED displays the battery's level of
charge. The LEDs start on the far right and move
to the left. Each LED indicates approximately 20%
of a full charge. When the LED at the far left is
flashing, the battery is nearly fully charged.
(Photo 17)
• I f you are finished charging, first remove the power
plug from the battery and put the cover cap back
over the charge plug. Then take the power plug from
the charger out of the socket.
The battery
15
16
17
69