Storch SSF 1200 Mode D'emploi page 55

The suction hose of the vacuum cleaner is being put
on the extraction duct of the SSF 1200. Depending
on the suction hose's dimensions you can use the
suction hose adaptor included in delivery.
The edge opening
The edge opening on the machine casing allows the
SSF 1200 to grind near proximity of edges using a
diamond grinding disc. For this purpose the extrac-
tor hood has to be removed from the machine casing
by disassembly the 2 black adjusting screws and the
orange locking screw.
Application examples: E. g. edges in pavements and
walls, door frames in the door and wall area.
Caution: The insert of the SSF 1200 for
grinding near edges has been exclusi-
vely designed for the use with the dia-
mond grinding disc. Depth limitation is
not possible because of the extractor
Caution!
hood being removed. Furthermore, the
suction of material being processed is strongly redu-
ced. Wear safety glasses and work gloves!
As soon as working near edges is completed, imme-
diately install extractor hood. Never work without
extractor hood when star-shaped milling cutters are
installed.
Removal of the milling head
CAUTION: Turn the machine off and UNPLUG THE
MAINS PLUG before working on milling heads.
CAUTION: The milling head can become very hot du-
ring the working process. Before replacing, allow the
milling head to cool down
1.
2. Tighten the orange locking screw (clock wise).
Extraction Duct
3. Use the T-wrench to loosen and remove the
Important: Subsequently loosen the orange locking
screw again in order to release the milling head.
4. In order do loosen the milling head use the ex-
5. Installation is in reverse order.
Replacing the star-shaped milling cutters
There are 2 different sets of star-shaped milling cut-
ters available:
•
•
55
NOTE: The orange locking screw to the
left of the Vacuum Connection is longer
than the two black adjusting screw.
Place the machine on a level and sturdy work-
space depositing it on its motor housing.
This locks the milling head.
middle clamping screw and washer.
Loosen middle clamping screw
tractor contained in the scope of delivery and
hook it under the heads of the 2 protruding fit-
ting bolts. Press the milling head away from the
machine by turning the extractor clockwise. Then
remove milling head.
Extractor
Pyramidal star-shaped milling cutters (scope of
delivery): For milling on hard surfaces. A rough
surface will be the result.
Angled star-shaped milling cutters (optional): For
milling on softer surfaces. A slightly rough sur-
face will be the result.
Translation of the original instruction