Storch SSF 1200 Mode D'emploi page 54

Caution: Never insert your fingers into
the grinding or milling head! After the
machine has been switched off, the
grinding / milling head will still rotate
Caution!
for a time. Take care that parts of your
body do not come into contact with the
rotating parts. Do not lay down the machine while
head is still turning!
Using the machine
Safe operation of this machine requires two-handed
operation for maximum protection and resistance to
the start-up and operating torque. To avoid loss of
control and thereby any damage or injury, the tool
should be held properly and securely WITH BOTH
HANDS. Protect your eyes from injury with adequate
safety glasses or goggles.
WARNING: Keep the cord behind the
operator and away from grinding area
to prevent it from becoming entangled
and damaged.
Caution!
The side handle can be attached to eit-
her side of the machine
Caution: Never apply too much pres-
sure to the machine. Let grind the ma-
chine.
Caution!
Milling depth regulation
The milling depth may be regulated by moving the
extractor hood. In order to do so, both the black ad-
justing screws have to be loosened. The orange lo-
cking screw is exclusively used for locking the milling
head during case of mounting or dismounting! During
operation this screw is always loose.
CAUTION: The orange locking screw must not be
tightened when adjusting the milling
depth. When switching the machine
on with the locking screw fastened this
may result in damaging the milling
head and in affecting the machine's
Caution!
performance negatively! After unplug-
ging the machine check the milling
heads ease of movement by hand before starting up
the machine.
NOTE: The milling depth can be adjusted by a remo-
val thickness of 1 mm to 6 mm.
Translation of the original instruction
Milling depth regulation
1. Turn power "OFF".
2. Unplug the machine from the socket.
3. Deposit the machine on it's motor case.
4. Loosen the 2 black adjustment screws and rota-
te the extractor hood to set the desired milling
depth. (There is no need to do anything with the
orange locking screw). See illustration.
5. Fasten the 2 black adjusting screws again.
Black adjusting screw
Extraction Duct
WARNING: Dust developing while
grinding and milling can be harm-
ful to one's health, and be flammab-
le or explosive. When operating the
SSF 1200 there should always be a
Caution!
powerful vacuum cleaner connected
(VacTec 25, art. no. 651500). In addition to that,
please always wear your personal protective equip-
ment (gloves / dust mask / safety glasses / overall).
Make sure that the working area is ventilated well.
The lifespan of milling discs are increased conside-
rably through the removal of dust particles.
Note: The extraction capacity of the material being
processed depends on the suction capacity of the
vacuum cleaner and on the work to be carried out.
When working on soft surfaces with a high removal
thickness (e.g. on sandy plaster) an emission of ma-
terial can not be avoided. In case of high amounts
of removal we recommend to use the STORCH coll-
ecting container for coarse dirt particles (art. no.
628100)
54
Orange Locking Knob