Storch SSF 1200 Mode D'emploi page 53

Attention: To avoid motor damage, this motor should
be blown out or vacuumed regularly to keep dust
from interfering with normal motor ventilation.
1. Connect this tool to a 230 V / 50 Hz power sup-
ply.
2. If the motor won't start after pressing the On/Off
switch, turn the switch "OFF" immediately, un-
plug the tool and check the machine for failures.
3. If the motor suddenly stalls while milling, release
the On/Off switch and unplug the tool. The motor
may now be restarted.
4. This machine is equipped with a thermo switch.
This switch may trip due to the following reasons
and it protects the machine from damage:
• Motor Is Overloaded - Overloading can occur if
you make too many start/stops in a short time.
• The pressure applied to the machine is too high.
• The mains voltage is too high or too low. The
nominal voltage should not be more than 10%
above or below the nameplate voltage.
• Extension cable is too long
• Conductor cross section is too small
• Ventilation slots are clogged
Extension cable
NOTE: Make sure the proper extension cord is used
and is in good condition. Use only 3-wire
extension cords that have 3-prong groun-
ding plugs and 3-pole receptacles that
accept the machine's plug. The use of
any extension cord will cause some loss
of power. In order to keep the loss mini-
mal and to avoid overheating of the machine make
sure that a minimum conductor cross section of 2.5
mm² is used.
Before using the machine
CAUTION:
med during
ling are
Work in well-ventilated areas only and
wear personal protective equipment
Caution!
as well as dust masks as prescribed.
Unpacking
The SSF 1200 is shipped completely in one trans-
port case.
• Remove the case and all loose parts from the
carton.
• Check the case content for completeness and put
all parts to an accurate visual inspection.
• Immediately complain about missing or defective
parts.
WARNING: If any parts are missing do not opera-
Dust being for-
grinding and mil-
harmful to health.
te your grinding and restoration cutter
until the missing parts are replaced.
Failure to do so could result in possib-
le serious injury.
Caution!
List of Contents
• Milling cutter
pyramidal milling wheels
• diamond grinding disc
• Installation kit for diamond grinding disc (con-
tains: long clamp screw, washer, spacer, counter
wrench)
• Side Handle
• Allen key
• Wheel puller
• Universal vacuum cleaner connection adapter
• Transport case
• Instruction manual
NOTE: Make sure that the power circuit voltage is
the same as that shown on the specifica-
tion plate of the machine and that switch
is "OFF" before connecting the machine
to the power circuit.
Lock - Off Trigger Switch
On - Press the Safety Lock then squeeze the trigger
switch to start.
NOTE: If the Safety Lock is not pushed first then
the machine will not start. Off - Release the trigger
switch to turn off.
53
Duo SSF 1200
"ON/OFF" switch
Translation of the original instruction
with