sylvac CBG Mode D'emploi page 16

10. Switching off
E
The dial gauge goes automatically into stand-by if not used for 10 minutes, unless Auto OFF mode has been turned off
(see Chap. 4, Second level functions)
CLEAR
123.456
Stand-by mode can be forced by a prolonged press (> 2 sec) on :
CLEAR
mm
>2s
In stand-by mode, the value of the origin is retained by the sensor (SIS mode), and the instrument automatically restarts
with any movement of the measurement probe, RS command, Bluetooth request or press of a button.
®
The instrument can be switched off completely for a long period of non-use, but this will necessitate a zero reset on restart
(the origin will be lost) :
CLEAR
123.456 OFF
- Prolonged press (>4 sec) on :
CLEAR
mm
>4s
11. Re-initialising the instrument
The initial instrument settings can be restored at any time by a prolonged press (>4 sec) simultaneously on and
CLEAR
MODE
until the message rESEt is displayed.
16