Taylor C004 Manuel D'utilisation Et D'entretien page 6

fig. 1
fig. 2
fig. 3
fig. 4
5 - ENGLISH
1.6 Start-up
In the tank a packet is present with the following
components for assembly:
sleeve, labyrinth, cock, drip collector.
- Insert the sleeve into the apposite guide, until it reaches
the pump inlet (pict1). Insert the labyrinth into the sleeve
(pict 2), insert the spacer (only C007)
- Mount the tap and turn it clockwise 45° (pict 3)
- Insert the drip collector into its seat (pict 4) Before
starting up the machine, it is necessary to thoroughly
clean all components and sterilize the parts in contact
with the product.
- The installation of the equipment shall be carried out by
authorized technical personnel only, that shall also take
care of maintenance according to the standards in force
- Make sure that the supply voltage and mains power
comply with the values reported on the rating plate
- Connect the machine to a power supply source with
efficient earthing contact, interpose an automatic safety
switch or provided with adequately rated fuses. The
feeder shall be well stretched, avoiding rolling and
overlapping. It must not be exposed to possible shocks
or tampering attempts; it must not be positioned near
liquids or water or source of heat; it must not be
damaged, if so, make it be replaced by qualified
personnel before connecting the machine to the mains
- Do not expose the machine to the sunlight or other
sources of heat
- Lay the equipment on a flat surface and leave at least 10
cm between the machine side panels and the walls or
other obstacles
- The side housing the air condenser shall be easily
accessible for cleaning.