Advance Planning; Before You Begin - Thermador PROFESSIONAL HPCN36NS Manuel D'installation

Advance Planning

Before You Begin

PARTS INCLUDED
1 – VTN1080 integral blower (HPCB
models only)
1 – Metal transition with backdraft
damper
2 or 3 – Stainless steel baffle filters
(depending on model size)
2 or 3 – Grease trays (depending on
model size)
1 – Remote blower adaptor
(HPCN models only)
1 – Wood bracket used as Hood
Mounting Bracket. Part of install –
DO NOT THROW AWAY.
1 – Fastener assortment*
Literature Packet
* Hardware provided is for mounting through standard
thickness drywall or plaster into wood studs. Installers
are responsible to provide hardware for other types of
mounting situations.
TOOLS AND PARTS NEEDED
Aluminum tape, DO NOT use duct tape
1/2" (13 mm) Conduit if required, follow local codes
1" (25.4 mm) Strain relief
Ducting as needed
Blower (HPCN36NS and HPCN48NS models only)
Torx head and phillips screwdrivers
Drill with ¼", 5/16", and countersink drill bits
3/8" (9 mm) nut driver or socket and ratchet
Wire stripper
Step Ladder
Tape Measure
Optional accessories are available for separate
purchase. For available options and dealer
information, visit our website at
www.thermador.com.
Chimney Extensions (see page 16 for available options)
25 ft. Blower Connector Cable for distances up to 25 ft.
(EXTNCB25)
Keep Hot Shelf
Backsplash
Remote Blower Roof Plate (RFPLT600 and RFPLT1000)
Remove all tape and packaging before using the
appliance. Please, recycle the packaging
material, as all THERMADOR appliance
packaging material is recyclable. Never allow
children to play with packaging material.
NOTE:
Do not throw away any packaging until appliance is fully
installed.
Stud Finder
Level
English 3