Cleaning The Filter - SOLIS PERFECT AIR Mode D'emploi

C LEAN I NG THE CH AS SIS
Regularly clean the chassis with a slightly moist towel and some mild detergent.
●
In general, please do not use any aggressive or abrasive detergents or metal
●
sponges for cleaning, as these might damage the surface.
CLE AN I NG THE FILTE R
Beneath the air filter cover on the back of the air humidifier, there is a mesh
●
filter. Should too much dust collect on the filter, the efficiency of the air humid-
GB
ifier is impaired, therefore, we recommend cleaning the mesh filter at least once
a month.
1. Remove the air inlet cover by pushing the two little flaps down and pulling the
cover away.
2. The removable black mesh filter lies beneath it.
3. Clean the mesh filter with a vacuum cleaner set to low power. Alternatively, you
can clean the filter with a soft brush.
4. After cleaning, place the filter back in the cover, then install the air inlet cover
so that it clicks into place. To do that, first insert the two bottom flaps and then
push the cover into the appliance.
Caution: Never use the appliance if mesh filter and air inlet cover have
●
not been properly installed.
110
STORAGE
s
Check if the appliance is switched off and the power plug is pulled resp. the
●
power cord is removed. The water has to be drained completely.
Check if the appliance inside is completely clean and dry. If necessary, let the
●
appliance stand open until the humidification mat and the water tub are dry
on the inside.
Keep the appliance standing upright in a dry, dark spot, best in the original
●
packaging. Do not place anything on the appliance.
Always keep the appliance and power cord out of the reach of children.
●
GB
111