Cleaning And Maintenance - SOLIS ULTRASONIC HYBRID 7214 Mode D'emploi

▲ ▲
C LEAN IN G A N D M AI NT E NANCE
1 . C LEA N I N G CA SI N G A N D WA TER T ANK
• Always switch off the appliance and pull the power plug before cleaning.
• Let appliance cool down completely.
• Regularly clean the water tank using clean water (at least once a week). Should
there be lime deposits in the water tank, add decalciier suitable for air humidi-
iers to the rinse water (f.e. SOLIPOL
• Clean the outer side of the appliance with a soft, damp cloth and a little of mild
washing-up liquid (when needed). Never dip the appliance in water and do not
spray it with water or other liquids.
• CAUTION: Never use aggressive or corrosive cleaning agents or a rough sponge.
The plastic casing might be damaged.
2. C LEA N I NG N E BUL IS A T IO N , H EA TING U NIT ,
NE B U LI S A T IO N CH A M BER A N D FEL T M AT
CAUTION: Always let the appliance cool down
completely before cleaning nebulisation, heating unit
and nebulisation chamber.
• Empty out the appliance.
• Remove mist duct and mist pipe as follows:
• Remove the mist pipe by turning it counter-
clockwise (ig.11).
• Grab the upper end of the mist duct and pull it off
in an upwards motion (ig.12+13).
• Clean the nebulisation chamber and heating unit
with a soft brush and rinse with water. Then, dry
both off with a cloth.
• The white felt mat lying on the heating unit
can be cleaned with clear water and some mild
detergent.
68
®
forte). Follow the directions on the bottle.
nebulisation chamber
ig.11
ig.12
ig.13
heating unit