Before First Use - SOLIS PERFECT AIR Mode D'emploi

BEFORE FIRST USE

s
Before using your air humidifier for the first time, remove all possibly attached
●
advertisement stickers (except for the type plate).
Should the appliance be stored at very low temperatures, you should let it stand
●
at room temperature for approx. 1 hour before starting to use it.
Only use the appliance when the room temperature lies somewhere between
●
5 °C and 40 °C. The relative humidity should not exceed 80 %. By the way: Rel-
ative humidity between 40 % and 60 % is ideal.
GB
Place the air humidifier on a stable, solid, dry, level and moisture resistant surface
●
where it can not be knocked over. A deep-pile rug or carpet is not a suitable
subsurface. Unimpeded air circulation around the appliance is extremely impor-
tant for proper humification. We recommend a minimum distance of 50 cm to
walls, heaters and other objects.
Carefully remove the tank by lifting it up by the handle.
●
Turn the water tank upside down and screw off the tank lid.
●
Hold the tank opening under a tap and fill it with fresh tap water. It is best to fill
●
the tank completely. You can check the water level through the inspection win-
dow. The water should not be completely cold but also not warmer than 30 °C.
Caution: Do not mix any additives like essential oils or perfumes into the
●
water! These additives damage the appliance resp. cause discolorations
to the plastic. Appliances that are damaged by adding additives are
excluded from warranty.
Note: Humidification will be even more effective if the filled water is not very
●
cold. However, the water temperature should not lie above 30 °C, as this might
damage parts of the appliance. To prevent fast calcification, you can use filtered
water if the water is very calciferous.
100
Pull the water tub out of the appliance. Make sure that the humidification mat is
●
properly placed in its frame in the water tub. Note: The markings on the bottom
of the water tub indicate the correct position for the humidification mat and its
mounting. Push the water tub all the way back into the appliance.
Screw the lid back onto the water tank and turn the tank upside down.
●
Place the water tank back in the appliance.
●
You should be able to hear the burbling water flow from the tank into the water
●
tub with the humidification mat.
Connect the power plug to the power socket. Press the ON/OFF button to
●
switch the appliance on. A signal sounds, the display states the current room air
humidity and the function light of the standard setting (High Speed) lights up.
You can now adjust the performance to your wishes.
Note: If you have filled the water tank for the first time, the water might smell or
●
change in colour. This is normal and has no negative effect on the functionality
of the appliance or your health.
GB
101