Table des Matières
Publicité
Installation
Installation
Supplies Required:
• Teflon tape and pipe sealant
• Piping to 1" NPT water supply inlet
• Adequate supply pipe supports
• Minimum 4" (102 mm) drain to accommodate
30 gallons (115 liters) per minute discharge
for shower waste
• Sign-mounting hardware
Local codes may require the installation of a
backflow prevention valve to complete proper
installation. Compliance with local codes is the
responsibility of the installer. Valve must be
tested annually to verify that it is functioning
properly. Backflow prevention valves are not
included with the fixture and may be supplied
by the contractor or purchased from Bradley
Corporation.
Step 1: Assemble components
1. 1Assemble the components as shown on page 4
(S19-130) or page 5 (S19-130A).
• Apply pipe sealant to all male-threaded pipe
joints.
• Use the rubber grip pad provided or a strap
wrench around pipes when tightening to
prevent marring. Place the grip pad on the
pipe, then put the wrench over the grip pad
and turn the pipe with the wrench.
• Bottom edge of showerhead should be 84"
(2134mm) from the floor.
Step 2: Connect water supply
IMPORTANT! Do not rely on Bradley's Drench
Shower to support supply piping.
1. Connect water supply piping to 1" NPT inlet
on unit (piping supplied by installer). Provide
adequate supports (supplied by installer) for
supply pipe using pipe hangers or other means.
2. Mount the safety sign to the wall using sign-
mounting hardware supplied by installer.
Bradley • 215-152 Rev. R; ECN 12-05-016G
S19-130
8"
6¼"
(203mm)
(158mm)
Ø 3¹⁄₁₀"
(79mm)
84"
(2134mm) to
Floor
S19-130A
9³⁄₈"
(238mm)
7¾"
(195mm)
Ø 10¾"
(273mm)
84"
(2134mm) to
Floor
All dimensions assume standard thread
engagement. Variations in manufacturing allow
for +/- ¹⁄₈" (3mm) per threaded joint. To find
the tolerance of a dimension, add the number
of thread joints in between a dimension and
multiply it by ¹⁄₈" (3mm).
11/8/2012
S19-130, S19-130A
25½"
(648mm)
9"
(229mm)
25½"
(648mm)
9"
(229mm)
3
Publicité
Table des Matières
