Inserting The Battery - Hilti TE 500-A36 Notice D'utilisation

6 Operation
6.1 Preparations at the workplace
Switch the product off or remove the battery before making adjustments
or changing accessories.
Observe the safety instructions and warnings in this documentation and on
the product.

6.1.1 Inserting the battery

CAUTION
Risk of injury by short circuit or falling battery!
▶ Before inserting the battery, make sure that the contacts on the battery
and the contacts on the product are free of foreign matter.
▶ Make sure that the battery always engages correctly.
1. Charge the battery fully before using it for the first time.
2. Push the battery into the battery holder until it engages with an audible
click.
3. Check that the battery is seated securely.
6.1.2 Removing the battery
1. Press the release buttons on the battery.
2. Pull the battery out of its holder in the device.
6.1.3 Charging the battery
1. Before charging the battery, read the operating instructions for the
charger.
2. Make sure that the contacts on the battery and the contacts on the
charger are clean and dry.
3. Use an approved charger to charge the battery.
6.1.4 Fitting the side handle
CAUTION
Risk of injury! Loss of control over the breaker.
▶ Check that the side handle is fitted correctly and tightened securely.
1. Switch off the power tool.
2. Release the side handle clamping band by turning the handle grip.
3. Slide the side handle clamping band over the chuck from the front and
into the recess provided.
4. Set the side handle to the desired position.
5. Tighten the side handle clamping band by turning the handle grip.
10 English
Printed: 16.07.2019 | Doc-Nr: PUB / 5503698 / 000 / 00
2
2240496
*2240496*