Release buttons (also used
(
to activate the charge status
indicator)
Battery
)
Side handle
+
3.2 Intended use
The product described is a cordless (battery-powered) breaker with pneu-
matic hammering mechanism. The product designed for light to medium
chiseling work on masonry and surface finishing work on concrete.
▶ Use only Hilti Li-ion batteries from the B 36 series with this product.
▶ Use only the Hilti battery chargers from the C4/36 series for these
batteries.
3.2.1 Possible misuse
• This product is not suitable for working on hazardous materials.
• This product is not suitable for working in a damp environment.
3.3 Active Vibration Reduction
The tool is equipped with an Active Vibration Reduction (AVR) system which
reduces vibration noticeably.
3.4 Service indicator
The product is equipped with a service indicator LED.
3.4.1 MMI
Status
The Service indicator lights up.
The Service indicator flashes.
The ON/OFF indicator lights up.
The ON/OFF indicator flashes.
The ON/OFF indicator is off.
The Half power indicator lights up.
The Half power indicator is off.
3.4.2 Lithiumion battery status display
The Li-ion battery state of charge and malfunctions of the power tool are
indicated by the display on the Liion battery. The Liion battery state of
charge is displayed after pressing one of the two battery release buttons.
8
English
Printed: 16.07.2019 | Doc-Nr: PUB / 5503698 / 000 / 00
On/off switch
§
Button for half power
/
Half-power indicator
:
Service indicator
∙
ON/OFF indicator
$
Meaning
Servicing is due.
Have the product repaired by Hilti
Service.
The product is switched on
The product is switched off be-
cause of a transient fault.
The product is switched off.
The product is working at half
power.
The product is working at full
power.
2240496
*2240496*