Symbols On The Product; Switching On And Off - Hilti TE 60-A36 Notice D'utilisation Originale

1.2.3 Symbols in the illustrations
The following symbols are used in illustrations:
These numbers refer to the corresponding illustrations found at the
beginning of these operating instructions
The numbering reflects the sequence of operations shown in the
illustrations and may deviate from the steps described in the text
Item reference numbers are used in the overview illustrations and
refer to the numbers used in the product overview section
This symbol is intended to draw special attention to certain points
when handling the product.
1.3 Product-dependent symbols

1.3.1 Symbols on the product

The following symbols are used on the product:
Drilling with hammering action (hammer drilling)
Chiseling
Chisel positioning
Protection class II (double-insulated)
Revolutions per minute
Rated speed under no load
Diameter
Direct current (DC)
Li-ion battery
Hilti Li-ion battery type series used. Observe the information given in
the section headed Intended use.
The product supports wireless data transmission compatible with
iOS and Android platforms.
Never use the battery as a striking tool.
Do not drop the battery. Never use a battery that has suffered an
impact or is damaged in any other way.

1.4 Switching on and off

Symbols
Product is switched on
Product is switched off
2 English 2201899
*2201899*