Care And Maintenance - Hilti TE 500-A36 Notice D'utilisation

Masquer les pouces Voir aussi pour TE 500-A36:

Notice d'utilisation originale (20 pages)

Mode d'emploi (76 pages)

Table Des Matières

Table des Matières

Les langues disponibles

6.3 Chisel positioning

CAUTION

Risk of injury! Loss of control over the chisel direction.

▶ Do not operate the tool when the selector switch is set to "Chisel

positioning". Turn the function selector switch until it engages in the

"Chiseling" position.

The chisel can be set to 24 different positions (in 15° increments). This

ensures that flat chisels and shaped chisels can always be set to the

optimum working position.

1. Switch off the power tool.

2. Set the function selector switch to the "Chisel positioning" position

3. Turn the chisel to the desired position.

4. Set the function selector switch to this symbol:

➥ The product is ready for use.

6.3.1 Chiseling

▶ Set the function selector switch to the "Chiseling" position

Use both hands to hold the product firmly. Keep the product clean

and free of oil and grease.

When the product is hot after working, do not place it on readily

flammable materials. These materials can ignite.

6.3.2 Switch sustained operation on and off

When chiseling, the control switch can be locked in the "on" position.

1. Push the lockbutton for continuous operation forward.

2. Press the control switch fully.

➥ The product then runs in sustained operating mode.

3. Push the lockbutton for continuous operation back.

➥ The product switches off.