Grease Filter - Novy 7550 Mode D'emploi Et D'installation

Technical information:
- Power supply: (2xAAA) batteries
- Frequence: 433.92Mhz
- Numbre of codes: 10
- Worktemperature: 0-50°C
- Dimensions: 110 x 50 x 19mm
3.4 InTouch
The cooker hood features the InTouch function. If you
have a Novy induction plate with InTouch, you can ope-
rate the hood from the plate. Programming InTouch on
the induction plate.
Programming InTouch on the induction plate
The remote control must first work with the hood. If ne-
cessary, the remote control code can be changed, as
described in Section 3.3.
Connect the plate to the mains supply.
1. Touch simultaneously the keys
duction plate until you hear a beep signal.
• The hob will now search for the hood code auto-
matically.
• WAIT until the hood lights flash, OR until you hear
a clicking sound eight times from the hood. (Be
patient, this may take a while)
2. Then touch any InTouch key,
the induction plate until you hear a beep signal. This
is the confirmation of the pairing of both devices.
Now you can operate the hood with the keys on the
induction plate.
4. MAINTENANCE

4.1. Grease filter

Maintenance of the grease filter
The cooker hood contains 4 metal grease filters. The
cooker hood has a cleaning indicator for the grease
filters.
Grease filter indication
Indication: green indicator lamp starts
burning.
After 20 cooking hours, an green lamp on the hood
indicates that the grease filter needs cleaning
Access to the filter
and on the in-
or or or on
The two side panels can be opened.
Attention: hold the hood with one hand and
open the side panel with the other hand.
Remove the filter by taking hold of its hook and pulling
down.
Cleaning the filter:
• in the dishwasher
• manually: in a hot solution of water and a liquid de-
tergent. Rinse and allow to dry completely
The previous instructions need to be followed. If
not an increased fire hazard may occur.
After cleaning, place the grease filters back in the hood.
Do not use the hood without the grease filters.
Reset grease filter indication
When you replace the monoblock filters after cleaning,
press the [+] and [-] buttons simultaneously for 5
seconds to reset the cleaning indicator. If you don't
reset, the green indication light will continu burn. We
advise you to clean your filter once a month for an
optimal operation.
4.2 Monoblock filters
In each grease filter there are 2 half round black mono-
block filters. Only use the Novy Monoblock recircula-
tion filter in the cooker hood.
Cleaning indication monoblock filter
Indication: orange indicator lamp starts
burning
EN 17