Single Standing Seam - Freund Seaming Pro Mode D'emploi

EN USER MANUAL

14. SINGLE STANDING SEAM

Before producing the single standing seam, it
must be ensured that the machine can enter the
panels. If this is not possible, the panel must be
pre-seamed to the length of the machine with a
squareseam folder.
The clips can be fastened in advance by a single
standing seam if required. The Seaming Pro can
run over a closed single standing seam.
To produce the single standing seam, attach the
rubberized drive rollers and the forming rollers
A and B, and close the tension lever. Make sure
that the cordless screwdriver is not ready for
operation when changing the rollers. Positions
C and D remain empty.
Subject to technical changes. Please observe the safety instructions.
37
WWW.FREUND-CIE.COM