Freund Seaming Pro Mode D'emploi page 33

9.2 Cutting pressure setting
Important: Cutting is performed at a lower pressure
than seaming. The pressure must be reduced at
the pressure setting screw.
The knurling on the cutting wheels is used to trans-
port the sheet metal that is being cut. The distance
between the knurls should be 1.2-1.8 mm (0.05" -
0.07"). Please check with feeler gauge. The rubber
wheels provide the forward drive of the machine
until the cutting wheels touch the sheet metal. In
order for the knurling to catch the sheet metal, the
seaming pro must then be pushed forward slightly.
WWW.FREUND-CIE.COM
Note: The distance between the rubber
wheels should be approximately the same
as the sheet thickness to be cut (e.g. 0.7
mm/ 0.03" for aluminum).
Distance of knurling between 1.2 and 1.8 mm (0.05" - 0.07")
Subject to technical changes. Please observe the safety instructions.
USER MANUAL EN
34