Sheet Thicknesses; Pressure Adjustment - Freund Seaming Pro Mode D'emploi

7. SHEET THICKNESSES

The Seaming Pro is factory set to common ma-
terials. Adjust the pressure setting if necessary.
Titanium zinc
Copper
Aluminum
Colored Steel
Galvanized Sheet Metal
Stainless Steel (max.
1.4301/ V2a und max.
500N/mm²) Forming rolls
made from special stainless
steel as accessories Item no.
93000010
Clips made from steel or
stainless steel
It is recommended to use the thinnest possible
clips (0.4 -0.5 mm / 0.015" – 0.02"), as these are
less visible in the finished seam.
When cutting off a standing seam roof, it is ne-
cessary to determine in advance if the thickness
of the clips meets the requirements.
WWW.FREUND-CIE.COM

8. PRESSURE ADJUSTMENT

The applied pressure can be changed by turning
the pressure adjustment screw with the supplied
hexagon socket wrench (6 mm / 0.25"). The pres-
Up to 0,70 mm
sure is reduced by turning the screw to the left.
(21 ga)
The pressure is increased by turning the screw to
Up to 0,70 mm
the right. The pressure must be checked during
(21ga)
work and adjusted if necessary. The pressure
Up to 0,70 mm
setting must be tested before starting work on
(21ga)
the sheet metal material used, including clips.
Up to 0,60 mm
The pressure setting can also be adjusted during
(22 ga)
seaming without opening the tension lever.
Up to 0,60 mm
(22 ga)
Up to 0,50 mm
(24ga)
Up to 0,60 mm
(22 ga)
Subject to technical changes. Please observe the safety instructions.
USER MANUAL EN
32