Installation Procedure - Toto TS930A1 Manuel D'installation Et D'utilisation

INSTALLATION PROCEDURE

N OTE: The product is heavy. Use the
recommended mounting support as
shown to suppor the shower prior to
installation.
1) Thoroughly clean and remove any de-
bris from the water supply pipe before
installation to prevent clogging the
spray outlet.
2) Complete the finished wall with a
1-1/2" clearance hole.
Slide the escutcheon and mount-
ing bracket onto the shower arm as
shown.
Apply an adequate amount of pipe
tape on the threads and thread the
shower arm into the supply elbow.
3) Slide the mounting bracket back
against the wall and tighten with pan
head screws and washers.
Secure the mounting bracket onto
the wall with mounting screws. Slide
the escutcheon toward the wall over
the mounting bracket.
FOR TS930A1/TS930A1L ONLY:
Make sure that the flow regulator
and gasket are both properly in-
stalled in the showerhead adapter.
Thread the showerhead adapter into
the shower arm adapter until it is
tight.
Adjust the showerhead so that the
TOTO logo is parallel to the wall
®
(slightly loosen the showerhead if
necessary), then tighten with set
screws.
2 x 4
Brace
1/2"
NPT
Elbow
2 x 6
Brace
1-1/2"
Clearance
Hole
Supply Line
Mounting
Bracket
1-1/2"
[40mm]
Escutcheon
TS930A1
TS930A1L
Head
Mounting
Screws
Screws
Washers
Shower
Arm
Adapter
Set
Screws
Flow
Regulator
Gasket
Showerhead
Adapter
4
4) Slide the mounting bracket back
against the wall and tighten with
pan head screws and washers.
Secure the mounting bracket onto
the wall with mounting screws.
Slide the escutcheon toward the
wall over the mounting bracket.
FOR TS100B1/TS100B1L ONLY:
Slide the shower arm adapter
upward so that the hex nut is ac-
cessible.
Make sure that the flow regula-
tor is properly installed into the
1-1/2"
Clearance
showerhead adapter and that the
Hole
gasket is inside the hex nut.
Thread the showerhead adapter
into the hex nut until tight.
Adjust the showerhead so that the
TOTO ® logo is parallel to the wall
(slightly loosen the showerhead if
necessary), then tighten with set
screws.
Slide the shower arm adapter over
the hex nut and thread it onto the
Pan
showerhead adapter.
Installation Procedure (continued)
TS100B1
TS100B1L
Mounting
Screws
Shower
Arm
Adapter
Flow
Regulator
5
Pan
Head
Screws
Washers
Set
Screws
Hex Nut
Gasket
Showerhead
Adapter