Deflating And Packing The Seat Cushion; Cleaning And Disinfection - Hill-Rom Primo P02033 Manuel D'utilisation

PROPRIETARY AND CONFIDENTIAL DRAFT: octobre 11, 2012
8. Connect the cushion hose to the non-return valve (E) of the seat cushion.
E
Wind the Velcro® straps (A) round the tube and close
9.

Deflating and packing the seat cushion

1. Open the cushion cover by separating the Velcro® straps on the folds on
the side of the cushion.
2. Locate the blue deflation valve and loosen the plug (G) by turning through a
½ turn anticlockwise.
3. Starting on the side opposite the valve, fold the cushion in order to expel the
air.
4. Close the plug and attach the Velcro® straps.
5. Store the seat cushion.
6. The device must be stored in its original packaging:
• protected against light and damp;
• at least 10 cm above floor level to prevent fluid ingress;
• protected against dust;
• outside passageways.

Cleaning and Disinfection

When cleaning, always check the seat cushion cover for cuts, tears, cracks or snags.
Hill-Rom recommends that damaged underlays should be scrapped.
Refer to chapter "Disinfection, servicing" page 25, up to paragraph "Disinfection"
page 28.
Page 34
A
A
G
.
170924(2) - EN - Primo User Manual
™