Operating The Shredder; Shredder Capacity - Genie 580 XCD Mode D'emploi

EN
with separate compartment for CD/DVD and credit cards
Dear customer,
Thank you for purchasing this GENIE quality product. Please carefully read the
operating instructions prior to the initial operation and keep them handy for future
reference.
Please pay particular attention to the following safety information. If you have any
questions or complaints about the device, please refer to the service information at the
end of these instructions.
Setup:
Place the CD/DVD & Credit card shredding plastic bin provided with your shredder, inside
1.
the appropriate rib position attached to the inside of waste bin.
Place the shredder securely on top of the wastebasket. Be sure not to allow your fingers to
2.
get between the basket and the shredder as you are placing the shredder in place.
Plug the power cord into any standard 220-240 volt AC outlet.
3.

Operating the shredder:

The Main Switch is located on the top of the shredder. The Main Switch has three (3)
settings.
1. When AUTO is selected, the shredding process is started automatically by inserting the
paper, a disk or a credit card into the feed opening. When inserting papers, please do not
shred CD/DVD and credit card at the same time. When inserting CD/DVD and credit card,
also please do not shred paper at that time .The shredder will stop automatically when the
paper, a disk or a credit card has completed its travel through the feed opening.
2. REV is used to assist in the removal of a paper jam, which reverses the shredder process
prior to a completed cycle, thus clearing the cutters.
3. OFF is used to terminate the AC power to the shredder. The mode is recommended when
emptying the wastebasket or when the shredder is not in use for a prolonged period of
time.

Shredder capacity:

GENIE 580 XCD Shredder
- 7
-