Genie 580 XCD Mode D'emploi page 9

Paper Jams and overload protection:
GENIE 580 XCD is equipped with a motor overload protection device. The normal short duty
cycle for continuous shredding at maximum capacity is 2 minutes. The power may terminate
automatically in case of the following abnormal situations:
Operating the shredder at the maximum capacity continuously for a prolonged period of
1.
time, e.g. more than 2 minutes for computer paper and CD/DVD or credit card without
stopping.
Exceeding the shredding capacity e.g. inserting more than eight (8) sheets at one pass, or
2.
if the paper is not fed squarely into the feed opening.
Both abnormal operations may result in the activation of the automatic motor overload
protection, which terminates the power to the unit .If this occurs, you should:
1. Unplug the power cord from the AC outlet to allow shredder to cool down. Tear or cut off
any excess paper from the top of the shredder.
2. Plug the power cord back into the AC outlet and place the Switch in REV. Pull the
remaining paper out of the cutters. Place the Switch back to the Auto position if necessary
clear the feed opening of any remaining shredded pieces of paper, Keep fingers away from
feed opening to avoid harm.
3. With the Main Switch in the AUTO position and the feed opening clear, you are now ready
to resume normal shredding.
Specifications:
Shred type:
Shred Size:
Shredding Capacity:
Feed Opening:
Feed Opening for CD/DVDs:
Input:
Shredding speed:
Basket capacity:
Security level(DIN 66399-2):
Cross cut
4x18 mm
8 Sheets or 1pc CD/DVD, or 1pc credit card
220mm for paper
120mm
220-240 volt AC, 50HZ ,1.0A
1,5m/min (8 sheets)
21 L
P-4
- 9
-