Operating The Shredder; Shredder Capacity - Genie 270 CD Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 12

Operating the shredder:

A switch is located on the top of the device and can be set in three (3) positions.
1.
AUTO position: the cutting process is automatically initiated as soon as paper, a CD/DVD
or credit card is inserted into the corresponding input slot. Please do not insert any
CDs/DVDs or credit cards into the input slot while shredding paper since the device is
incapable of shredding of paper at the same time as CDs/DVDs or credit cards. Once the
chosen material has fully passed through the cutting unit, the cutting process will stop
automatically.
2.
FWD is used to shred credit cards and CDs / DVDs, set the switch to FWD and insert the
CDs / DVDs into the slot behind the flap.
3.
REV is used to fix paper blockages. This changes the cutting direction before an operating
cycle has ended enabling the blades to be released. If you realise that you have
unintentionally inserted too much paper, and the shredding process becomes noticeably
slower, set the switch to this position.
4.
The switch should be set to OFF if you wish to empty the paper basket, or do not intend to
use the device for an extended period. After doing so, unplug the device from the power
supply.
The device is only intended for personal use indoors and for an intermittent
operation period of a maximum of 2 minutes. Do not use the shredder for
commercial purposes or outdoors.

Shredder capacity:

The 270 CD is capable of shredding up to 7 sheets of paper (DIN A4, 80g
width may not exceed 22cm. When shredding small pieces of paper, such as envelopes or
credit card receipts, the paper should be inserted in the middle of the opening. Please ensure
that you never insert more than the stated maximum quantity into the cutting unit as this may
damage the device.
How to operate:
Set the switch on the front side to "AUTO". The device will then be ready to operate.
Shredding paper
Insert a maximum of 7 sheets of paper (80g/m²) in portrait orientation into the input slot. The
paper will be recognised by the sensors, the cutting unit will start and the paper will be
automatically drawn in. The operation will finish once there is no more paper in the cutting unit.
Overloading:
If you insert too much paper, the cutting unit will stop. In this event, set the switch to "REV" in
order to remove the paper. Reduce the number of sheets and then try again.
Overheating:
If you exceed the indicated maximum operating time of 2 minutes, there is a possibility of the
motor overheating. In this event, the cutting unit will stop. The drive will be automatically
disconnected from the power and will restart on its own once the motor has cooled down
sufficiently. You should therefore set the switch to the "OFF" position and let the device cool
- 9
-
) at once. Paper
/m²

Publicité

Table des Matières
loading

Table des Matières