Infection Control Procedures - Dentsply Sirona Cavitron Mode D'emploi

2. Fill entire handpiece with water.
3. Lubricate O-ring (black or green rubber material) with water.
4. Gently twist the insert down into the handpiece until the
insert is fully seated in place.
5. Use the lowest effective power setting.
6. Adjust the water control until the water (lavage) flows with a
rapid drip or small spray.
7. Use very light pressure with a light pen or modified pen
grasp.
8. Use a light but stable intraoral or extraoral fulcrum.
9. Adapt the insert so the point is not directed into root
surface
4
10. Use a light, smooth gentle touch.
11. Keep the insert tip in motion at all times, using overlapping
horizontal, vertical or oblique brush-like strokes.
12. Use the inactivated insert to explore/evaluate root surface.

INFECTION CONTROL PROCEDURES

Warnings
• All devices should be cleaned and sterilized before each use.
For the countries that require a three-step process, in which
disinfection is required prior to sterilization, all devices must be
cleaned, disinfected and sterilized before use.
• High-level disinfection by itself is not appropriate for these devices.
Limitations on Processing
• Repeated processing has minimal effect; end of life is normally
determined by wear and damage due to use.
• Always use a pH neutral instrument cleaning solution (such as