Inventum IKI6032 Mode D'emploi page 20

• Damage caused by incorrect connection, incorrect fitting, or
incorrect use is not covered by the warranty.
• If the connecting cable is damaged, it may only be replaced
by the manufacturer, the manufacturer's service organisation
or equivalently qualified persons, in order to avoid dangerous
situations.
• The electrical connection must comply with national and local
regulations.
• The wall plug socket and plug should always be accessible.
• For connecting, use an approved cable with the correct cable
diameters appropriate for the connection. The cable casing should
be made of rubber (preferably a cable that meets the directive
60227 IEC 53).
• The connection cable must hang freely and should not be fed
through a drawer. Attention: the maximum power cord length is 200
cm.
• The worktop into which the hob is fitted, should be flat.
• The walls and the worktop surrounding the appliance must be heat
resistant up to at least 85°C. Even though the appliance itself does
not get hot, the heat of a hot pan could discolour or deform the wall.
• Legislation requires that all electrical and electronic
equipment must be collected for reuse and recycling.
Electrical and electronic equipment marked with the symbol
indicating separate collection of such equipment must be
returned to a municipal waste collection point.
20
• English