Safety Information - brennenstuhl JARO Mode D'emploi

Operating Instructions
D
Tripod for individual floodlight 20 W:
Tripod for individual floodlight 30/50 W:
Tripod for double floodlight 2 x 20 W:
ASSEMBLY OF THE LED FLOODLIGHT ON THE TRIPOD
Loosen the locking screw (C). Fold out the feet completely.
Afterwards, re-tighten the locking screw (C).
There are two arrows at the tube. These mark the area
where the ring of the feet (1) have to be placed
to ensure sufficient stability of the tripod. The
refore make sure that the ring of the feet (1)
matches insides the arrows area.
Fasten the LED floodlight by means of the locking screw (A) at the central hole of the fastening
bracket on the tripod.
To change the tripod height, loosen the tube nuts (B). Extend the tripod up to the desired height
and re-tighten the tube nuts (B).

SAFETY INFORMATION

1. Before use, always check the floodlight and the power supply line for any possible damage.
Never use the floodlight in case of any damage.
Caution! In case of a damaged floodlight or a damaged power supply line there will be a risk
of fatal injury from electrical current!
8
18P083 Mobiler_Stativ LED Strahler Jaro 498291 181120.indd 8
extendible from 75 cm to 160 cm
extendible from 86 cm to 152 cm
extendible from 82 cm to 142 cm
A Mounting screw
B Tube nuts
C Locking screw
1
JARO
20.11.2018 13:52:41