Electronic Control Panel (Only For Sof-Poe-2) - Softena SOF-POE-1 Instructions D'installation Et D'emploi

ELECTRONIC CONTROL PANEL (only for SOF-POE-2)

Picture 7
symbol button
SCROLL
UP
POWER-UP
Whenever the electronic controller or the power supply is
(re)connected to the appliance, the drain motor will
automatically be activated and run until it reaches the service
position, i.e. drain is closed.
POWER FAILURE
In the event of a power failure, the program will remain
stored in the NOVRAM® during an undefined period.
When the power failure occurs during the execution of an
automatic backwash, the appliance will remain in the
backwash position; when the power supply is re-established,
the appliance will return to the service position, stay there for
10 sec. and restart a backwash.
SERVICE MODE
In service mode the display alternates every 5 seconds
between:
-
the number of days since the last backwash:
D
-
the water usage (in m 3 or tons) since the last backwash:
T
BACKWASH MODE
In backwash mode the display shows the remaining
backwash time (in sec):
The appliance can be reset to service mode at any time by
pressing the scroll and up
holding them for 3 sec.
CHECKING THE FLOW METER
In case of water usage, the indication 'T' in the display will
blink. This way the correct functioning of the water meter can
be verified.
T
function
to advance to the next
parameter
to increase the value of the
parameter
buttons simultaneously and
MANUAL BACKWASH
It is possible to manually initiate a backwash.
1. Press the scroll
hold them for 3 sec until the display shows:
2. The drain motor will be activated and run until it reaches
the backwash position, i.e. drain is open.
PROGRAMMING INSTRUCTIONS

Before entering the programming mode, make sure that
the appliance is in the service mode.

In case no button is pressed in a period of 10 sec, the
control panel will automatically return to the service mode;
any changes made will NOT be saved!
1. Press the scroll
display shows the number of days between backwashes:
D
units
tens
hundreds
•
Press the up
•
Press the scroll
•
Press the up
•
Press the scroll
•
Press the up
2. Press the scroll
volume of water (in m
T
•
Press the up
•
Press the scroll
•
Press the up
•
Press the scroll
•
Press the up
3. Press the scroll
length of the backwash (in seconds):
•
Press the up
•
Press the scroll
•
Press the up
•
Press the scroll
•
Press the up
4. Press the scroll
the NOVRAM® and exit the programming mode.
Page 7
and up buttons simultaneously and
button and hold it for 3 sec until the
button to set the units.
button again.
button to set the tens.
button again.
button to set the hundreds.
button again; the display shows the
3
or tons) between backwashes:
button to set the units.
button again.
button to set the tens.
button again.
button to set the hundreds.
button again; the display shows the
button to set the units.
button again.
button to set the tens.
button again.
button to set the hundreds.
button again to save the settings into
EN - English