Care & Maintenance; Air Filter; Error Codes - Danby DPTA090HEB1WDB Manuel Du Propriétaire

CARE & MAINTENANCE

AIR FILTER

The air fi lter should be cleaned approximately every
2 weeks. The air fi lter may require more frequent
cleaning if there is signifi cant dander or fur in the
air.
The air fi lter is located behind the front intake grill.
Grasp the fi lter by the center and pull up and out.
Use a vacuum cleaner with a soft brush attachment
to remove any large debris or dust build up from the
air fi lter.
Wash the fi lter in lukewarm, soapy water, below
40°C (104°F), or use a neutral cleaning agent.
Rinse the fi lter with clean water and dry thoroughly
before reinstalling in the appliance.
Note: Do not operate the appliance without the air
fi lter installed.
CLEANING
To avoid possible electric shock, ensure that the
appliance is unplugged before performing any
cleaning or maintenance.
The outside of the appliance can be wiped clean
with a soft cloth or with a lukewarm, damp cloth if
necessary.
Do not use gasoline, benzene, thinner or any
other chemicals to clean this appliance as these
substances can cause damage to the fi nish and
deformation of plastic parts.
Never pour water directly onto the appliance as this
will cause deterioration of electrical components
and wiring insulation.

ERROR CODES

If any of the below error codes appear on the
display, unplug the appliance and then plug it back
1 in. If the error code persists, call for service.
AS - room temperature sensor error
ES - evaporator temperature sensor error
CS - condenser temperature sensor error
OS - outside temperature sensor error
HS - exhaust temperature sensor error
LE - wire controller error
LO - room temperature is lower than 0°C / 32°F
HI - room temperature is higher than 37°C / 99°F
FP - low temperature protection
2
9