Reset Function - Futurelight PHS-750E Mode D'emploi

Adjust dimming speed
With this function you can adjust the dimming speed.
Caution:
If several connected devices should be dimmed and there are devices with older software-versions, the
dimm speed SLOW must be selected in order to maintain compatibility!
Automatic PAN/TILT calibration
With this function you can calibrate the PAN/TILT movement to the correct starting position.
Adjust PAN/TILT speed
With this function you can define the PAN/TILT speed. You can select one of 4 different modes.
Mic sensitivity
With this function, you can select the desired microphone sensitivity between 0 % and 99 %.
• Select "Mic sensitivity" by pressing Up or Down.
• Press the Enter-button, the display shows "M-70".
• Press Up or Down to select the desired sensitivity.
• Press the Enter-button to confirm.
• Press the Mode/Esc-button in order to return to the main menu.
Service setting
The password for this function is „050".
Adjust ventilation fans mode
With this function, you can adjust the ventilation fans mode.
• Select "Fan Voltage" by pressing Up or Down.
• Press Enter to confirm; the display shows "LOW".
• Press Up or Down to select "LOW" or "HIGH".
• Press the Enter-button to confirm.
• Press the Mode/Esc-button in order to return to the main menu.
Gobo rotation mode select
With this function you can select the gobo rotation mode.
• Select "Gobo speed" by pressing Up or Down.
• Press Enter to confirm; the display shows "SLOW".
• Press Up or Down to select "SLOW" or "QUICK".
• Press the Enter-button to confirm.
• Press the Mode/Esc-button in order to return to the main menu.
Adjust fan speed
With this function you can adjust the fan voltage selected under ventilation fan mode even further. In this
way, you can select „Auto fans speed", „High fans speed" and „Low fans speed".
Display close time
With this function you can shut off the LED display after 1 to 59 minutes.
Select temperature designation
With this function you can select the temperature designation.
• Select "Temperature C/F" by pressing Up or Down.
• Press the Enter-button, the display shows "Celsius".
• Press Up or Down to select the desired degree between "Celsius" and "Fahrenheit".
• Press the Enter-button to confirm.
• Press the Mode/Esc-button in order to return to the main menu.
Initial effect
With this function, you can adjust with which value the respective channels will start.

Reset function

With this function you can reset the device via the Control Board. You can select the different Reset-
functions by pressing Up or Down.
58/120 00024321.DOC, Version 1.4