Futurelight PHS-750E Mode D'emploi page 60

To start a Auto Program please proceed as follows:
1.Slave-Setting
• Select "Function Mode" by pressing Up or Down.
• Press the Enter-button to confirm.
• Select "Set to slave" by pressing Up or Down.
• Press the Enter-button to confirm.
• Press Up or Down to select "Slave 1", "Slave 2" or "Slave 3".
• Press the Enter-button to confirm.
• Press the Mode/Esc-button in order to return to the main menu.
2. Automatic Program Run
• Select "Function Mode" by pressing Up or Down.
• Press the Enter-button to confirm.
• Select "Auto Program" by pressing Up or Down.
• Press the Enter-button to confirm.
• Press Up or Down to select "Master" or "Alone". The selection "Alone" means Stand Alone-mode and
"Master" that the device is defined as master.
• Press the Enter-button to confirm.
• Press the Mode/Esc-button in order to return to the main menu.
3. Program selection for Auto Pro Part
• Select "Edit program" by pressing Up or Down.
• Press the Enter-button to confirm.
• Select "Select programs" by pressing Up or Down.
• Press the Enter-button to confirm.
• Press Up or Down to select "Auto Pro Part 1", "Auto Pro Part 2" or "Auto Pro Part 3", and thus select
which Slave program is to be sent. Selection „Part 1" means, that the Slave unit runs the same program as
the master units.
• Press the Enter-button to confirm.
• Press the Mode/Esc-button in order to return to the main menu.
4. Program selection for Edit Program
• Select "Edit program" by pressing Up or Down.
• Press the Enter-button to confirm.
• Select "Edit program" by pressing Up or Down.
• Press the Enter-button to confirm.
• Press Up or Down to select the desired program. With this function you can edit specific scenes into a
specific program.
• Press the Enter-button to confirm.
• Press the Mode/Esc-button in order to return to the main menu.
5. Automatic Scene Recording
• Select "Edit program" by pressing Up or Down.
• Press the Enter-button to confirm.
• Select "Edit scenes" by pressing Up or Down.
• Press the Enter-button to confirm.
• Press Up or Down to select the desired scene numbers. You can program a maximum number of 250
scenes.
• Press the Enter-button to confirm.
• Press Up or Down to select the desired value.
• Press the Enter-button to confirm.
• Press the Mode/Esc-button in order to return to the main menu.
60/120 00024321.DOC, Version 1.4