Maintenance; Cleaning; Grease Filter; Replacing The Light Bulb - Elica Salice Série Guide D'utilisation, D'entretien Et D'installation

Maintenance

ATTENTION! Before performing any maintenance operation, isolate the hood from the electrical supply by switching off at the
connector and removing the connector fuse.
Or if the appliance has been connected through a plug and socket, then the plug must be removed from the socket.

Cleaning

Do not spray cleaners directly to the control while
cleaning the Hood. The cooker hood should be cleaned
regularly (at least with the same frequency with which you
externally. Clean using the cloth dampened with neutral
liquid detergent. Do not use abrasive products.
USE ALCOHOL!
WARNING:
Failure to carry out the basic cleaning recommendations of
Therefore, we recommend oserving these instructions.
The manufacturer declines all responsibility for any damage
maintenance or failure to observe the above safety
recommendations.

Grease Filter

Traps cooking grease particles.
This must be cleaned once a month using non aggressive
detergents, either by hand or in the dishwasher, which must
be set to a low temperature and a short cycle. When
DO NOT
linked to inappropriate
19

Replacing the light bulb

CAUTION
Before replacing the lamps, switch power off at service
panel and lock service panel disconnecting means to
prevent power from being switched on accidentally.
NOTE: Turn off the lights and fan. Allow the lights to
cool before handling. If new lights do not operate be
sure lights are inserted correctly before calling service.
Replace Lights
Remove the damaged light (twist counter clockwise)
and replace with a new 120 Volt, 50 Watt (maximum)
50° halogen light made for a GU10 base, suitable
use in open luminarie.