Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Maintenance
Cleaning
Do not spray cleaners directly to the control while cleaning the
Hood. The cooker hood should be cleaned regularly (at least
with the same frequency with which you carry out maintenance
of the fat filters) internally and externally. Clean using the
cloth dampened with neutral liquid detergent. Do not use
abrasive products.
DO NOT USE ALCOHOL!
I
WARNING:
Failure to carry out the basic cleaning recommendations of the
cooker hood and replacement of the filters may cause fire risks.
Therefore, we recommend oserving these instructions.
The manufacturer declines all responsibility for any damage to
the motor or any fire damage linked to inappropriate maintenance
or failure to observe the above safety recommendations.
Metal grease filter
The filters should be washed frequently. Place metal filters in
dishwasher or hot detergent solution to clean. Let filter dry
thoroughly before replacing it.
Turn off fan and lights. Allow lamps to cool.
1
Remove each filter by pushing down the spring release
handle and then pulling down the filter.
2
Wash metal filters as needed in dishwasher or hot
detergent solution.
3
Reinstall the filter by making sure the spring release
handles are toward the front. Insert metal grease filter into
upper track.
4
Pull the spring release handle down.
5
Push up on metal filter and release handle to latch into
place.
6
Repeat steps 1-5 for the other filter.
Replacing a LED lamp
The LED lights are replaceable by a service technician only.
See "Who to contact" section in the warranty for service
contact information.
Available accessories
Recirculating kit
If it is not possible to vent cooking fumes and vapors to the
outside, the range hood can be used in the non-vented
(recirculating) version, using a charcoal filter. Recirculation Kit
is available from the dealer or an authorized parts distributor.
A
G
B
D
F
E
H
A.
Ceiling
B.
Vent cover
C.
Soffit
D.
6" (15.2 cm) vent
E.
Range hood
NOTE: 12" (30.5 cm) high cabinets without a soffit may allow
the 6" vent and vent cover to be seen.
1
Cover the grill that protects the suction motor with the
carbon filter so that the slots on the filter correspond to
the pins on the sides of the motor protection grill.
2
Turn the carbon filter clockwise to block them (bayonet
fixing).
The charcoal filters cannot be cleaned. It should be
•
replaced every 4-6 months (depending on hood usage).
Remove the cable ties in the carbon filter to be able to
•
turning it clockwise.
Extension liner kit
30" wide x 17" or 20" deep liner provides complete
•
protection of the cabinets.
•
36" wide x 17" or 20" deep liner provides complete
protection of the cabinets.
See Liner installation instructions for more detail.
G
F
I
F.
Cabinet
G.
Wall
H.
12" (30.5 cm) min. cabinet height
I.
17" (43.2 cm) min. vent cover height
A
B
C
D
E
11
Publicité
Table des Matières
