Elica Salice Série Guide D'utilisation, D'entretien Et D'installation page 11

Attach the vertical duct cover supports using 4 screws.
Place upper duct covers sliding through until spring
sounds "click".
Then verify.
Place lower duct covers using one plastic bracket at
each vertex (4 needed).
The lower duct cover shall be secured to rangehood by 4
screws.
Install the grease filter and turn power on at service panel.
Check operation of the hood.
If range hood does not operate:
Check that the circuit breaker is not tripped or the house
fuse blown.
Disconnect power supply. Check that wiring is correct.
To get the most efficient use from your new range hood,
read the "Use and Care Information" section.
Keep your Installation Instructions and Use and Care
Guide close to range hood for easy reference.
11