Sony SU-FL300M Mode D'emploi page 10

Step 5:
Safety measures to
prevent toppling over
WARNING
Be sure to take measures to prevent the TV Stand from
toppling over, and causing possible injury and damage.
1
Attach the support belt.
1 Screw the support belt to the TV Stand with the
supplied wood screw using the screwdriver.
2 Attach the support belt to the Table-Top Stand, and
screw the belt with the supplied securing screw
using a coin, etc.
3 Adjust the length by tightening the support belt
while holding the Table-Top Stand.
10
(GB)
2
Connect the cables.
Run the cables through the cable holders and the Rear
Pillar holes.
Note
If the cables are not installed properly, they might be pinched
and damaged, and could result in electric shock, etc.
3
Anchor the TV to the wall.
Prepare a strong, commercially-available rope or chain
and wall anchor bracket for this purpose.
1 Secure the wall anchor bracket to a solid wall.
2 Pass the rope or chain through both holes of the
anchor bolts and then tighten the other end of the
rope or chain to the wall anchor bracket.
Strong rope or
chain
Wall anchor bracket