Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
NOTICE:
To install planer blades, clean out all
chips or foreign matter adhering to the drum or
the planer blades. Use planer blades of the same
dimensions and weight, otherwise drum oscilla-
tion/vibration, causing poor planing action, and
tool breakdown will result.
For tool with conventional planer
blades
1.
To remove the conventional planer blades from
the tool, unscrew the installation bolts with the box
wrench.
The drum plate and the conventional planer blade
with adjusting plate come off.
1
3
► 1. Box wrench 2. Installation bolt 3. Drum plate
4. Conventional blade (with adjusting plate)
2.
Unscrew and remove the adjusting plate.
► 1. Screw 2. Adjusting plate 3. Conventional planer
blade
3.
To install the conventional planer blades, place
the conventional planer blade on the blade gauge
so that the blade edge is perfectly flush with the
inside edge of the blade gauge.
4.
Place the adjusting plate on the conventional
planer blade, then simply press in the heel of the
adjusting plate flush with the backside of the blade
gauge.
2
4
3
2
1
5.
Tighten two screws on the adjusting plate while
the adjusting plate being pressed.
6
5
2
1
2
1
► 1. Blade gauge 2. Inside edge of blade gauge
3. Conventional planer blade 4. Blade edge (of con-
ventional planer blade) 5. Adjusting plate 6. Screw
7. Heel
6.
Clean out all chips or foreign matter adhering to
the drum and the conventional planer blade.
7.
Slip the heel of the adjusting plate into the drum
groove, then fit the drum plate on it.
1
► 1. Drum groove 2. Heel 3. Drum plate 4. Installation
bolt
8.
Tighten all the installation bolts evenly and alter-
nately with the box wrench.
9.
Repeat the above procedures for the other con-
ventional planer blade.
9 ENGLISH
4
4
6
5
3
3
2
7
3
7
4
Publicité
Table des Matières
