Connect Drain Hose; Connect Inlet Hoses - Whirlpool YLTE5243DQ5 Instructions Pour L'installation

Connect Drain Hose

Proper connection of the drain hose protects your floors from
damage due to water leakage. To prevent the drain hose from
coming off or leaking, it must be installed per the following
instructions:
IMPORTANT: To ensure proper installation, this procedure must
be followed exactly.
1. Check the drain hose to see whether it is the proper length.
2. Wet the inside of the straight end of the drain hose with tap
water. DO NOT USE ANY OTHER LUBRICANT.
3. Squeeze ears of the silver, double-wire clamp with pliers to
open. Place clamp over the straight end of the drain hose
¼ in. (6.4 mm) from the end.
4. Open clamp. Twist hose back and forth while pushing onto
drain connector on the side of the washer/dryer. Continue until
hose contacts the ribbed stops on the cabinet.
5. Place clamp over the area marked "CLAMP." Release clamp.
For laundry tub or standpipe drain systems
1. Open the yellow, single-wire clamp and slide over the hooked
end of the drain hose to secure the rubber and corrugated
sections together.
1. Hooked end
2. Drain hose
2. Put the hooked end of drain hose into laundry tub or
standpipe. Rotate hook to eliminate kinks.
To prevent drain water from going back into the washer:
Do not straighten hooked end of the drain hose and force
excess drain hose into standpipe. Hose should be secure
but loose enough to provide a gap for air.
Do not lay excess hose on the bottom of the laundry tub.
6
For use with floor drain
Remove the drain hose hook from the corrugated drain hose. You
may need additional parts. See "Floor Drain" under "Alternate
Parts."
1. Insert a new flat washer (supplied) into each end of the inlet
Connect the inlet hoses to the water faucets
.
Make sure the washer basket is empty.
2. Attach the hose with the red coupling to the hot water faucet.
3. Attach the hose with the blue coupling to the cold water
4. Using pliers, tighten the couplings with an additional two-
NOTE: Do not overtighten. Damage to the valves can result.
Clear the water lines
5. Run water through both faucets and inlet hoses, into a bucket
Connect the inlet hoses to the washer
6. Attach the hose with the blue coupling to the cold (top) inlet
NOTE: Do not overtighten. Damage to the valves can result.
7. Attach the hose with the red coupling to the hot water
NOTE: Do not overtighten. Damage to the valves can result.

Connect Inlet Hoses

hoses. Firmly seat the washers in the couplings.
1
1. Coupling
2. Washer
Screw on coupling by hand until seated on the washer.
faucet. Screw on coupling by hand until seated on the washer.
thirds turn.
or laundry tub, to get rid of particles in the water lines that
might clog the inlet valve screens.
valve. Screw on coupling by hand until seated on the washer.
Using pliers, tighten the couplings with an additional two-
thirds turn.
1. Cold water inlet valve (blue)
2. Hot water inlet valve (red)
(bottom) inlet valve. Screw on coupling by hand until seated
on the washer. Using pliers, tighten the couplings with an
additional two-thirds turn.
2
1
2