Glatz PALAZZO Royal Notice De Montage Et D'utilisation page 13

• Straighten up pole (9) carefully and still hold firmly (fig. 4).
• Insert safety screw (5).
• Adjust upright position with plate screws (11), if necessary.
• Align sunshade.
• Lower jacking ring (3) onto pole base and insert and tighten ancho-
ring screws (12) (fig. 5).
• Insert theft protection and lock.
Fig. 4
9
11
11
5
12
3
Fig. 5
3.4 Installing the Roof Struts Preparation (2 adults are required):
1 person to stand on a stable ladder or platform
1 person on the ground to assist
• Screw long roof struts with the axle support (4) onto the crown-
shaped disc (3), with welting channels (7) facing out. The support
strut of the first roof strut must also be fastened to the sliding disc
before mounting the other roof struts.
• With square or rectangular sunshades, the hole numbers from the
rail (5) and crown-shaped disc (3) must correspond.
• Screw the support struts onto the sliding disc in the same way.
1
2
3
4
5
6
7
Fig. 6
13
• Screws (do not use Loctite) (1)
• Disks (2)
• Crown-shaped disc with hole
numbers (3)
• Axle support (4)
• Numbered roof support insert (5)
• Roof-strut profile with welting
channels (6)
• Welting channels (7)
|EN