Setting The Clock; Detaching The Front Panel - Sony CDX-GT710 Mode D'emploi

Setting the clock

The clock uses a 24-hour digital indication.
1
Press (MENU).
2
Rotate the volume control dial until
"Clock Adjust" appears, then press
(ENTER).
The clock adjustment display appears.
3
Rotate the volume control dial to set
the hour and minute.
To move the digital indication, press (SEEK)
+/–.
4
After setting the minute, press
(ENTER).
The clock starts.
With the card remote commander
In steps 2 to 3: press M or m instead of the volume
control dial; in step 3: press < or , instead of
(SEEK) –/+.
Tip
You can set the clock automatically with the RDS
feature (page 12).

Detaching the front panel

You can detach the front panel of this unit to
prevent theft.
Caution alarm
If you turn the ignition switch to the OFF
position without detaching the front panel, the
caution alarm will sound for a few seconds.
The alarm will only sound if the built-in
amplifier is used.
1
Press (OFF).
The unit is turned off.
2
Press .
The left side of front panel is released.
3
Slide the front panel to the left, then
gently pull out the front panel towards
you.
Notes
• Do not drop or put excessive pressure on the front
panel and display window.
• Do not subject the front panel to heat/high
temperature or moisture. Avoid leaving it in a parked
car or on a dashboard/rear tray.
(OFF)
5