Trevi CD 512 Mode D'emploi Et D'installation page 8

CD 512
ENGLISH
BASIC FUNCTION
Switching on the unit
Press the PLAY/PAUSE/STANDBY button.
Set the FUNCTION switch to CD/AUX or RADIO position to turn on the unit.
NOTE: In CD/AUX position, when the unit is not providing the main function for 15 minutes, the unit will automatically
switch into standby mode.
ESD hints
The product maybe reset or not reset to operation of control due to electrostatic discharge, just switch off and reconnect again.
Volume adjusting
Switch VOLUME knob down or up to increase or decrease volume.
USING THE RADIO
TUNING IN RADIO STATIONS
1. Move the FUNCTION switch to RADIO position, the POWER indicator will illuminate.
2. Tune to required station by rotating the TUNING KNOB.
3. Rotate the VOLUME CONTROL to comfortable volume level.
4. Extend the TELESCOPIC ANTENNA to its full length if you are listening to FM broadcasting.
5. Turn off the radio by switching the FUNCTION switch to "OFF" position.
USING THE CD
Set the FUNCTION SWITCH to "CD/AUX" position. Press the CD door LIFT TO OPEN to open the CD door to put in a compact
disc. Close it and start reading. The LED display always shows the tracks of a disc which are still to be played.
Playing The Entire Disc
1. Playback will start by pressing CD PLAY/PAUSE/STANDBY button, playback starts with the first track. The display will show
the current track number.
2. To interrupt playback, press CD PLAY/PAUSE/STANDBY button.
3. To resume playback, press CD PLAY/PAUSE/STANDBY button once again.
4. To stop playback, press CD STOP button.
Note:
1. To ensure good system performance; wait until the disc tray completely reads the disc
2. If no disc is loaded into the compartment, or the disc is placed upside down, the display will show "N0".
SELECTING A DESIRED TRACK/PASSAGE
To select a desired track
1. Press SKIP/SEARCH NEXT/BACK button repeatedly in stop mode or during play until the desired track appears on the
display.
2. Press PLAY/PAUSE/STANDBY button to start play.
To search for a particular passage during playback (track scanning at high speed)
1. Press and hold SKIP/SEARCH BACK/NEXT button to scan the current playing track at high speed until desired point(passage),
then release the button.
2. Playback will start again from this point.
REPEAT PLAY
When playing, press REPEAT button once. REPEAT INDICATOR will light up and flash for playing the same track only. If repeat all
tracks, press the REPEAT button again, REPEAT INDICATOR will light up and steady. To cancel repeat play, press the REPEAT
button until the repeat indicator disappears.
PROGRAM PLAY
1. Press "PROG" button to make program memory in stop mode.
2. " 01 " will be shown flashing on the display, Program indicator will light up and flash.
3. Press CD SKIP/SEARCH NEXT/BACK button to select a track number. The track number will show "1".
4. Press the "PROG" button to store the track number.
5. " 02 " flashes again. Repeat step (3) to (4) to program other desired tracks.
6. Press "PROG" button once more after 20 track in programmed and all the programmed track numbers will be shown one by
one
7. Press CD PLAY/PAUSE/STANDBY button, playback will start from the first programmed track.
8. You can press CD SKIP SEARCH NEXT/BACK button to select the track number in memory.
9. In stop mode, press STOP button to cancel the program play and the program indicator will disappear.
RANDOM PLAY
Press the CD RANDOM button in Play/Stop mode, the current track number and "- - " will flashing again and again. And then
8
before proceeding.