fetra 2122 Mode D'emploi page 45

Use the ▼, ▲and ↵ keys to set the middle calibration weight (eg. 1250kg) as descri-
•
bed above. Confirm all segments with ↵ until the ~ pointer is flashing.
• Lift the calibration weight (in the above mentioned example 1250kg).
Press the ↵ key for about 4 seconds to confirm. The display counts down to "AF00".
•
The middle calibration value is displayed. The middle calibration weight can be
lowered.
Press the ▲ key, the NET + ~ pointers are flashing, the last calibration value can now
•
be entered.
Press the ↵ key shortly, the right segment starts flashing.
•
Use the ▼, ▲and ↵ keys to set the last calibration weight (eg. 1875kg) as described
•
above. Confirm all segments with ↵ until the NET + ~ pointers are flashing.
• Lift the calibration weight (in the above mentioned example 1875kg).
Press the ↵ key for about 4 seconds to confirm. The display counts down to "AF00".
•
The last calibration value is displayed.
Press the ▲ key to leave the calibration mode, the weigh systems displays eg. AP 11
•
(internal value).
Press the key for about 4 seconds, the system returns to standard weighing mode,
•
shows the actual weight on the forks, the calibration is completed and the calibrati-
on load can be lowered.
Attention: When a weighing system is calibrated using the multi-point calibration, the
smallest weight should be used first, then the middle weight and finally the largest
weight. If only 1 calibration weight is used, then values 2 and 3 must be set to "00000".
45
Transport equipment