Installation
The following section describes how to install the wireless opening
detector on the leaf of the window or door.
(Installation on a window or door frame follows the same procedure.)
10 mm
Position and screw on the backplate
The holes for the fixing screws must be aligned in the
direction of the wall (and not aligned with the centre of
the door/window).
Distance from the door/window edge: 10 mm
(Figure shows window with DIN on right; installation
with DIN on left follows the same procedure.)
Attach motherboard housing
Attach the motherboard housing in the correct position
and press this into place.
(Figure shows window with DIN on right; installation
with DIN on left follows the same procedure.)
- 10 -